The JME Audio/Visual Radiation Alarm is a tool to assist Radiographers in environments where controlled exposure bays are not possible. Typical applications are landlines and offshore pipeline barges.
The JME Audio/Visual Radiation Alarm is normally used close to the area of x-ray emission to indicate visually and audibly the presence of Ionising Radiation.
The JME Audio/Visual Radiation Alarm has a built in battery charger to enable the internal battery to be recharged without removing the battery. Typical battery recharge time is approximately 12 hours.
Please Note: This is not a personnel radiation monitor nor should be used as one.
|Power Requirements||12V DC 5Ah Sealed Lead Acid Battery|
|Construction||Sealed Polycarbonate case with Polymide handle and side plates|
||Lamps (each): 200mA (pulsed @ 1Hz)
Control Circuit: 20mA
|Sounder Volume||95dB @ 1M|
||Continuous: Radiation Imminent
Intermittent: Radiation on
|Radiation Detection Circuit||Sensitivity: 20 μSv/h|
|Operating Time (continuous)||Approx. 14Hrs|
|Charger (supplied with unit)
||Input: 90-264VAC, 57-63Hz
Output: 13.7VDC 1A
|Operating Temperature||-20°c to +50°c|
|Overall Dimensions (mm)
(aerial in open configuration)
|254 x 89.5 x 400|
|Radio Range||2 Kilometres|